Petrol tank liner kit fuel flush and rust converter pre epoxy coating kit 20lt

Tankroxx Extreme duty petrol tank flush and rust convertor, Suitable for most motorcycle size tanks. Pre treatment before tank lining with Tankroxx epoy products.

Tank flush and converter only 2 x 1 litre NO EPOXY. High build solvent free 2k epoxy coating designed to provide outstanding chemical and corrosion protection. Specially formulated for tank lining repair and restoration. Use for new lining or to replace failed tank liner eg.

Kreem, Por15, slosh, etc 1k polyurethane poor quality coatings. Tried and tested not only on Petrol, Ethanol and Diesel. Ammonia Hydroxide and many more. Corrosion 5000hrs min ASTM B117. Cure times- 20C (do not attempt if temp is below 10C). Usable pot life for fill and rotate method 25minutes. Cure to hard 24 hours. Post cure for use 7 days. Tankroxx will cover and fill pinholes, seam splits and minor surface rust without the need for other lengthy operations. But to be completely safe its best to try to clean and de rust as much of the surface as you can. Step 1 Remove all oil fuel varnish from the tank using Tankroxx solvent flush or similar. Step 2 Remove all loose rust and debris from tank, again wash all out with Tankroxx solvent.

Step 3 Treat rust with Tankroxx rust remover convertor, agitate tank with suitable bead shot or metal nuts screw etc. Step 4 Wash out with Tankroxx solvent or similar again. Leave to fully dry out.

Step 5 Mix Coating thoroughly, pour into plugged, masked paint protected tank and swirl around to coat the entire surface for 15-20 minutes. Leave to dry upside down for 24 hours. Full instructions included in every pack.

Colour when dry is Red.

---